Modarabbit is reader-supported. When you buy through links on our site, we may earn an affiliate commission. Learn more

Share on facebook
Share
Share on twitter
Tweet
Share on pinterest
Save

How to make a wall plaque out of wood?

The majority of people want to make a wall plaque out of wood for decoration, gifts, and different purposes. Put your accessory on top of your wood. In order to place your decorative supply to the center of your wood, you can place the paper on your wood and measure its size. To make a cleaner cut, you can draw your wood according to the quarter circles that you drew before drilling.

Making special display pieces that will be shown to others.

Also check out how to make Spotify Glass Wall decor without using cricut.

Table of Contents

make a wall plaque out of wood

Choosing the wood type-wall plaque out of wood

The first thing you can do is choosing your wood type. Gather different pieces of wood together and also care about your accossory that you want to display on. Line them up, put the little pick and decorative supply on them, and just see which one was the best combination to leap out at your wood.
This is a perfect way to pick your wood-wall-decorative supply combination.

Make Corners of the semi circle cutaways

Once you choose your favorite wood place your decorative accesorries on each piece of wood. Then for step 2 you can make the four corners of the semi circle cutaways to help give the wood a little more appeal than just a rectangular piece of wood. Again, using quarter cutaways in each corner, try some different sizes before drilling operation. Since drawing equally gives the wood and the tools a pleasant balance.

Trace and cut them off to make edges smooth

Trace these out and cut them off on the scroll saw, then sanded my orbital sander in some detail. It is necessary to ensure that all the edges are smooth without bumps and that the semi circles are perfectly sanded because you may want to put an edge on the wood.
If there are any bumps or imperfections, the bearing will telegraph the defect into the wood on the bottom of the router bit, and the cut will be an obvious mistake. The only way to repair this is to re-route and sand the edge smooth.

Drilling a hole of your wooden plaque

Drill a hole in the slightly upper half of the plaque, a 15-20 inches, after the routing, only to fit the wire that would have to go through the hole to hold the instruments to your wood plaque.
Last but not least, drill a small hole in the back of the plaque before adding the tools with the fine wire. Be careful about that before purchasing so that it would allow it to be hanged on the wall.

If you’d rather watch a video on how to do it step by step, take a glance at this video here:

You can also buy wood wall decor plaques from etsy.com

Share on facebook
Share
Share on twitter
Tweet
Share on pinterest
Pinterest